Inorganic Interior Wall Paint
Product Parameter
| Ingredients | water; inorganic emulsion; environmental pigment |
| Viscosity | 95Pa.s |
| pH value | 7.5 |
| Water resistance | 5000 times |
| Theoretical coverage | 0.93 |
| Drying time | Surface dry for 45 minutes (25°C) and hard dry for 12 hours (25°C) for more than 7 days to achieve the best performance Low temperature conditions will prolong the drying time. |
| Solid content | 45% |
| Country of origin | Made in China |
| Model NO. | BPR-1011 |
| Proportion | 1.3 |
| Physical state | white viscous liquid |
Product Application
It is suitable for painting public areas such as hospitals and schools and decoration of middle and high-end homes.
Product Features
♦ Excellent flame retardancy
♦ Excellent mildew and antibacterial properties
♦ Strong air permeability
♦ Super weather resistance
♦ Good environmental performance
Product Construction
Application instructions
The surface must be clean, dry, neutral, flat, free of floating dust, oil stains and sundries, the leaking part must be sealed, and the surface must be polished and smoothed before painting to ensure that the surface humidity of the pre-coated substrate is less than 10%, and the pH value is less than 10.
The quality of the paint effect depends on the flatness of the base layer.
Application conditions
Please do not apply in wet or cold weather (the temperature is below 5°C and the relative degree is above 85%) or the expected coating effect will not be achieved.
Please use it in a well ventilated place. If you really need to work in a closed environment, you must install ventilation and use appropriate protective devices.
Tool Cleaning
Please use clean water to wash all utensils on time after stopping in the middle of painting and after painting.
Coating system and coating times
♦ Base surface treatment: remove dust, oil stains, cracks, etc. on the base surface, spray glue or interface agent to increase adhesion and alkali resistance.
♦ Putty scraping: Fill the uneven part of the wall with low alkaline putty, scrape twice horizontally and vertically alternately, and smooth it with sandpaper after scraping each time.
♦ Primer: Brush a layer with a special primer to increase coating strength and adhesion of the paint.
♦ Brush topcoat: according to the type and requirements of the paint, brush two to three topcoats, wait for drying between each layer, and refill putty and smooth.
Theoretical paint consumption
9.0-10 square meters/kg/single pass (dry film 30 microns), due to the roughness of the actual construction surface and the dilution ratio, the amount of paint consumption is also different.
Packaging specification
20KG
Storage method
Store in a cool and dry warehouse at 0°C-35°C, avoid rain and sun exposure, and strictly prevent frost. Avoid stacking too high.
Points to Attention
Executive standard
The product meets the GB8624-2012A standard
It does not burn at high temperature of 1200℃. Does not produce toxic gas.
Safety, Health and Environmental Instructions
Be sure to read the application instructions in the package text carefully before use to obtain a reliable and satisfactory coating effect. Try to open all doors and windows before starting operation and use them to ensure proper ventilation in the construction area. Allergic skin, please always wear protective equipment during use; if you accidentally contaminate your eyes, please rinse with plenty of water immediately and seek medical assistance. Do not let children or pets enter the construction area, and keep the product out of reach; if accidentally contaminated, rinse with plenty of water immediately and seek medical assistance. When the paint is overturned and leaking, cover it with sand or soil and collect and dispose of it properly. Do not pour paint into the sewer or drain. When disposing of paint waste, comply with local environmental standards.
For detailed information on health and safety and precautions for using this product, please refer to our company's "Product Safety Data Sheet".
Product construction steps
Product Display
